Contents
DS storage manager
* https://delivery04.dhe.ibm.com/sar/CMA/SDA/05lpo/3/
Change V7000 default passwords
For best security practices, it is always recommended that you change the default passwords for the superuser, root, and admin passwords. Make sure you record the new passwords in a secure location. Note: A good password should be at least eight characters in length and contain a mix of uppercase letters, lowercase letters, and numbers. Procedure
- First ssh to the file module management IP address (refer to Table 1) using port 22. Log in with user ID admin and password admin.
Change the default superuser password for the control enclosure. Issue command svctask chuser -password superuser_password superuser, where superuser_password is the new superuser password that you want to use. The password must be a minimum of 6 characters.
- Change the default root password for the management node. Issue command chrootpwd and follow the prompts to change the password. The password must be a minimum of 5 characters.
- Change the default admin password for the management node. Issue command chuser admin -p new_password where new_password is the new password that you want to use. The password must be a minimum of 8 characters.
Type exit to close the connection.
resetting V7000 password
- 1.找个FAT32格式的空U盘中， 2.把附件的TXT的文件放到U盘中， 3.然后把U盘插到存储后面的USB口（当前操作的控制器上）， 4.等大约5分钟，再尝试用默认的用户名和密码登陆。
默认用户名：superuser 默认密码：passw0rd 本操作不影响存储运行。
Reset IBM DS3524 / DS3512 RAID Manager Password
You’ve locked yourself out of the IBM Storage Manager, have you? Or perhaps you’ve gotten yourself a used unit, but have no password for it.
Telnet to both controllers IP-addresses (or use serial console via 4pin mini DIN plug in top left corner of both controllers), and type
VxWorks login: shellUsr Password: wy3oo&w4 (not shown as you enter it) -> loadDebug value = 1 = 0x1 -> setSAPassword_MT "" ReturnCode = 0x1 value = 1 = 0x1 -> unld "Debug" value = 0 = 0x0 -> exit
This removes the password, so you can configure through the DS Storage Manager without entering a password. Log on to controller B and follow the same steps.
No need to reboot, it should work immediately.
What is the console password for an IBM DS4700 SAN?
The username/password may be one of the following combinations:
shellUsr/wy3oo&w4
shellUsr/infiniti
shellUsr/y2llojpThese steps worked for me on firmware version 7.70: First, connect remotely on telnet using the user name: shellUsr The password for shellUsr is wy3oo&w4 Alternate passwords may be infiniti or y2llojp according to IBM System Storage:User and password for serial port on DS4700 (fw version 7.15) Next, enter the command spriMenuPwdReset and enter y at the confirmation. Alternate commands for older firmware versions (6.60 and 7.60) are clearSYMbolPassword and symbolPwdReset